Passer au contenu principal
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Créez et accédez à une liste de vos produits
Certains numéros d’article ont peut-être changé. Si ce n’est pas ce que vous recherchez, essayez de faire une recherche sur tous les articles. Rechercher des articles

Enable HTTPS/SSH and disable HTTP/Telnet for switch management on PowerConnect 8000 and 8100 series switches.

Résumé: This article provides the steps necessary to restrict management access using HTTPS and SSH.

Cet article concerne Cet article ne concerne pas Cet article n’est associé à aucun produit spécifique. Toutes les versions du produit ne sont pas identifiées dans cet article.

Instructions

This procedure assumes:

The switch is already configured with an IP address and is reachable within the network.

There is an account created with Privilege Level 15.  To verify this, use the command: console#show users accounts

Caution:
The 8000 and 8100 series requires a Privileged Exec (Enable) mode password for telnet/SSH management. Failure to set this password will result in severely limited CLI management ability with SSH.  ***Add link to setting enable password via web and CLI
This process requires use of the Command Line Interface (CLI). This process can be utilized through a serial or telnet session. However if telnet is used, these steps must be followed in order to prevent unintentionally blocking access to remote management.
Before disabling either telnet or HTTP access, verify SSH or HTTPS access.
 
Note: After completing these steps, you can expect to receive errors about certificate authenticity. This is due to the certificates and keys being self-generated. This is not an error.

 

Note: If SSH or HTTPS is enabled and the disabling of telnet and HTTP is desired, skip to step 3 to disable telnet and step 5 to disable HTTP.
This system is capable of the generation and storage of 2 certificates. To generate the second key, replace the number 1 with 2. To activate the second key, use (config)# ip http secure-certificate 2.
 
  1. Connect to the switch via CLI
  2. To enable SSH, enter the following commands:
    1. console>enable
    2. console#config
    3. console(config)#crypto key generate rsa
    4. console(config)#ip ssh server
  3. To disable telnet, enter:  console(config)# ip telnet server disable
  4. To enable HTTPS, enter the following commands"
    1. console(config)# crypto certificate 1 generate
    2. console(config-crypto-cert)#key-generate <512-2048>
    3. console(config-crypto-cert)#exit
    4. console(config)# ip http secure-server
  5. To disable HTTP, enter:  console(config)# no ip http server
  6. After verifying connectivity via SSH or HTTPS, save the configuration by entering:  console#copy running-config startup-config

 

Produits concernés

PowerConnect 8024, PowerConnect 8024F, PowerConnect 8100 Series
Propriétés de l’article
Numéro d’article: 000120235
Type d’article: How To
Dernière modification: 21 févr. 2021
Version:  5
Trouvez des réponses à vos questions auprès d’autres utilisateurs Dell
Services de support
Vérifiez si votre appareil est couvert par les services de support.