Symptômes
A new APC Uninterruptible Power Supply (UPS) is usually shipped with the battery disconnected. This article explains how to connect the battery.
Cause
NOTE: In Compliance with Department Of Transportation (DOT) regulations, APC Uninterruptible power supply (UPS) are shipped with the battery disconnected. The unit will not operate until the battery is connected.
Résolution
Connect the Battery in the New APC UPS
If you receive a APC UPS which does not function, please make sure the battery is connected. Perform the following steps:
-
Open the battery compartment
-
Pull the battery out half way
-
Connect the Red Battery Wire to the + Positive battery terminal
-
Push the battery into the compartment and re-install the cover
NOTE: Batteries on average take at least 6 hours to charge. For additional information on connecting and charging the battery, go to the
APC Manual Page.
Produits concernés
Dell UPS 1000R, Dell UPS 1920R, Dell UPS 2700R, Dell UPS 5600R, Dell UPS 1920T, Dell UPS 500T, Dell UPS 3750R, Dell UPS 4200R, Liebert NX UPS