Passer au contenu principal
Quitter

Bienvenue dans l’univers Dell

Mon compte
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Profitez de récompenses et de remises réservées aux membres
  • Créez et accédez à une liste de vos produits
Se connecter Créer un compte Connexion au compte Premier Connexion au programme de partenariat
Nous contacter

Vos paniers Dell.com

OptiPlex 5090 Micro Form Factor (MFF) Teardown removal guide for customer replaceable unit (CRUs)

Résumé: This article is a guide to removing those parts of the Dell Micro Form Factor OptiPlex 5090 desktop system that Dell considers it easy enough for anyone to do.

Cet article concerne Cet article ne concerne pas Cet article n’est associé à aucun produit spécifique. Toutes les versions du produit ne sont pas identifiées dans cet article.
Consulter d’autres ressources

Instructions

These guides take you step-by-step through the safe removal of the Customer Replaceable Unit (CRU) parts of a OptiPlex 5090 system. (CRUs are the parts of the system that should not need an engineer to remove or replace.) The guides include pictures to reference what is involved.

Table of Contents:

  1. CRU Removal Guide

  2. Removal Instructions

 

Removal Guide

 

If these guides do not cover what you are looking to do, then you will want to reference your System Manual.

The article below provides information about safe practices to consider before working with electrical equipment.


Back to Top

 

Removal Instructions

 

Note: Click the title of the section you want to open below, in order to see the contents.

 

|

 

Recommended Tools

 

1 Small Phillip's head screwdriver 2 Plastic Scribe
3 Small Flat head screwdriver    
 
Note: Be aware that using a large Phillips or Flat Head screwdriver may result in damage to the head of the screws. This would make their removal impossible without specialty tools, that are not available to our onsite engineers.

 

  1. Pre-Removal Instructions Before removing the System Cover:

    1. During installation or removals of any hardware always ensure that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

  2. Looking at the rear of your PC, loosen the thumbscrew that secures the cover to the chassis.

Access Panel

  1. Push the cover towards the front of the PC. Lift the access panel away when the securing lugs are released.

Access Panel 2

 

  1. Pre-Removal Instructions Before removing the Hard Disk Drive (HDD):

    1. During installation or removals of any hardware always ensure that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Please remove the System Cover.

  2. This system can fit a single 2½ inch HDD in the front left-hand side corner of the system. Press the blue tabs toward each other and pull the bracket towards you out the front of the computer.

HDD

  1. Lift the blue bracket up and out of the system.

HDD 2

  1. Pull the two securing grommets on one side of the blue bracket away from the drive, the drive then should pull loose of the other side.

HDD 3

 

  1. Pre-Removal Instructions Before removing the Solid State Drive (SSD):

    1. During installation or removals of any hardware always ensure that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Please remove the System Cover, and Drive Assembly.

The M.2 2230 PCIe SSD:

  1. You can find the slot for the M.2 in rear left-hand side corner of the system under the drive bracket. Remove the single screw securing the card to the motherboard.

2230 SSD

  1. The end of the card lifts up, grip it and pull it out of the connector and the system.

The M.2 2280 PCIe SSD:

  1. You can find the slot for the M.2 along the left-hand side of the system under the drive bracket. Remove the single screw securing the card to the motherboard.

2280 SSD

  1. The end of the card lifts up, grip it and pull it out of the connector and the system.

 

  1. Pre-Removal Instructions Before removing the Fan Assembly:

    1. During installation or removals of any hardware always ensure that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Please remove the System Cover.

  2. The fan along the right-hand side of the chassis. Unroute the speaker cable from the front of the ducting.

Fan

  1. Press the blue tabs in the middle of duct towards each other. Turn the fan assembly over and disconnect the fan cable.

Fan 2

  1. Lift the ducting and fan away from the system.

 

  1. Pre-Removal Instructions Before removing the Memory:

    1. During installation or removals of any hardware always ensure that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Please remove the System Cover, and Fan Assembly.

  2. The memory slots are located underneath the fan assembly. Pull the securing clips on either side of the DIMM away from the DIMM to see it lift up out of the slot.

Memory

  1. Pull the memory DIMM out of the slot and the chassis.

Note: Repeat these steps for any additional memory DIMMs located in the system.

 

  1. Pre-Removal Instructions Before removing the Coin Cell Battery:

    1. During installation or removals of any hardware always ensure that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Please remove the System Cover.

  2. The coin cell battery is located between at the rear left-hand side of the system. Using a plastic scribe or similar tool, pry back the latch and release the battery.

Coin Cell Battery

  1. Lift the battery up and out of the connector.

 

  1. Pre-Removal Instructions Before removing the Internal Speaker:

    1. During installation or removals of any hardware always ensure that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Please remove the System Cover, and Fan Assembly.

  2. The speaker is located at the front of the system. Disconnect the speaker cable from the motherboard.

Speaker

  1. Pull the tab on the rear of the speaker assembly and lift it out of the chassis

 

  1. Pre-Removal Instructions Before removing the WLAN (WiFi, Wireless) Card:

    1. During installation or removals of any hardware always ensure that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Please remove the System Cover, and Drive Assembly.

  2. The Wireless card slot is located in the front left-hand side corner of the system under the drive bracket. Using a non-metallic tool to pry open the WLAN card shielding cover.

WLAN

  1. Remove the single screw locking down the antenna bracket. Disconnect the WiFi antenna cables from the card. (The connector is a press stud and should pop off the card when you apply a little pressure.)

WLAN

  1. Pull the card out of the slot and the system.

If you require further assistance, please contact technical Support.
Contact Us OptiPlex 5090 Customer replaceable unit (CRU) teardown index

Produits concernés

OptiPlex 5090 Tower, OptiPlex 5090 Micro, OptiPlex 5090 Small Form Factor
Propriétés de l’article
Numéro d’article: 000186541
Type d’article: How To
Dernière modification: 29 juin 2023
Version:  2
Trouvez des réponses à vos questions auprès d’autres utilisateurs Dell
Services de support
Vérifiez si votre appareil est couvert par les services de support.