Siirry pääsisältöön
Kirjaudu ulos

Tervetuloa Dellin asiakkaaksi

Oma tili
  • Tee tilauksia nopeasti ja helposti
  • Tarkastele tilauksia ja seuraa lähetyksen tilaa
  • Luo tuoteluettelo ja käytä sitä
Kirjaudu sisään Luo tili Premier-kirjautuminen Kumppaniohjelman sisäänkirjautumissivu
Ota yhteyttä

GPS Module Cannot Be Awakened after Latitude Rugged 5430 and Rugged Extreme 7330 Laptop Resumes from Sleep

Yhteenveto: The following article provides information about a Global Positioning System (GPS) module that cannot be awakened. This is seen after the Latitude Rugged 5430, and Rugged Extreme 7330 laptop resumes from sleep. ...

Tämä artikkeli koskee tuotetta Tämä artikkeli ei koske tuotetta Tämä artikkeli ei liity tiettyyn tuotteeseen. Tässä artikkelissa ei yksilöidä kaikkia tuoteversioita.
Tutustu muihin resursseihin

Oireet

GPS module cannot be awakened to access NMEA data using the UART interface

 

Owners of the Latitude Rugged 5430 and Latitude Rugged Extreme 7330 laptop find the following issue with the M9N Global Positioning System (GPS) module:

The GPS module fails to wake-up and provide access to National Marine Electronics Association (NMEA) data. This occurs under the following conditions:

  • The laptop runs the Windows 11 operating system.
  • The laptop goes to sleep or idles for over 1 minute.
  • The map application is closed.
  • You attempt to check the NMEA Global Navigation Satellite System (GNSS) data.


Back to Top

 

Syy

The Universal Asynchronous Receiver/Transmitter (UART) interface cannot communicate while in a Suspend state.

The Universal GNSS (UGNSS) driver supports both Selective Suspend and DFx.

The Windows Hardware Lab Kit (HLK) certification requires this driver to pass. GNSS is stopped to reduce the power consumption.

The module and driver are working as designed.


Back to Top

 

Tarkkuus

The module and driver are working as designed. However, you can configure the driver to allow the UGNSS to get the NMEA data from the UART interface. You can do this by disabling the suspend mode. However, you need to be aware that this affects the power consumption on your laptop.

The following step-by-step instructions take you through disabling suspend:

  1. Open the Device Manager utility in Windows:

    • You can click the Start Menu, type Device Manager and choose the option from the search results.

    • You can press the Windows Key and the Pause Key together.

    • You can right-click the Windows Key and select Device Manager from the Power Users menu that appears.

  2. Browse down to the Sensors section.

  3. Open the section and right click on u-blox Universal GNSS.

  4. Select properties from the menu that appears. (see Figure.1)

    Device Manager

    (Figure.1 Device Manager)

  5. Go to and select the Power Management tab.

  6. Clear the check box for the option to Allow the computer to turn off this device to save power. (see Figure.2)

    Power Management

    (Figure.2 Power Management)

Note: This increases the power consumption of your computer. So if you want the laptop to maximize the battery life for Modern Standby at any time. You need to go back in and check this option. However, the issue with the GPS returns.
 

Back to Top

 

Tuotteet, joihin vaikutus kohdistuu

Latitude 7330 Rugged Extreme, Latitude 5430 Rugged
Artikkelin ominaisuudet
Artikkelin numero: 000193834
Artikkelin tyyppi: Solution
Viimeksi muutettu: 25 syysk. 2024
Versio:  3
Etsi vastauksia kysymyksiisi muilta Dell-käyttäjiltä
Tukipalvelut
Tarkista, kuuluuko laitteesi tukipalveluiden piiriin.