Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos
Es posible que algunos números de artículo hayan cambiado. Si esto no es lo que está buscando, intente buscar todos los artículos. Buscar artículos

TPM Option Is Missing in the System BIOS Setup Latitude, Precision, or XPS

Resumen: The Trusted Platform Module (TPM) option may be missing in the system BIOS or Windows Operating System on your Dell Latitude, Dell Precision, or XPS system. Follow the steps outlined in this article to resolve this issue. ...

Este artículo se aplica a Este artículo no se aplica a Este artículo no está vinculado a ningún producto específico. No se identifican todas las versiones del producto en este artículo.
Consulte estos recursos

Síntomas

You may encounter a situation where the Trusted Platform Module (TPM) 2.0 option is missing from the BIOS setup screen, the Security option, or that there is no TPM present when running the Trusted Platform Module Microsoft management console (TPM.msc) in Windows.

This issue may become apparent as the result of a BitLocker recovery message.

NOTE: This only applies to platforms that support or can be switched to TPM 2.0. (Skylake and Newer systems.)

Computers with encrypted hard drives installed may also experience a no-boot situation if the TPM option is missing. Check the BIOS settings to ensure that TPM is not missing. Also, follow the steps below to resolve the missing TPM issue if a no-boot occurs on an encrypted hard drive.

Causa

No cause information

Resolución

NOTE: Dell Technologies recommends that the entire installation base of applicable systems are updated, not just systems that are presenting issues with TPM.

If you are using UEFI boot mode, it is recommended to download and install the latest TPM 2.0 firmware version from Dell Support on applicable systems. The firmware is located under the Security category in the list of drivers. This new TPM 2.0 firmware should prevent this issue from occurring in the future.

If using Legacy boot mode, download and install the latest TPM 1.2 firmware version from the Dell Drivers & Downloads website on your applicable systems. The firmware is located under the Security category in the list of drivers.

NOTE: See our article on: How to Successfully Update the TPM Firmware on your Dell Computer.
NOTE: Search for drivers on the Dell Support Website by system model, not the service tag, as depending on the service tag entitlement, the TPM firmware files may not be displayed.

If TPM is not present, try the following troubleshooting steps:

  1. Update the system BIOS to the latest version available on the Dell Drivers & Downloads website.
  2. Power off the computer, then disconnect the AC power cable and leave the computer unplugged for about 30 seconds.
  3. Reconnect AC power to the computer and boot to the BIOS setup using the F12 one-time boot menu.
    NOTE: To ensure that TPM is turned on, you must press F2 to enter System Setup. Then go to the Security section and check that TPM is set to On under the TPM security settings.
  4. If TPM is restored, proceed with normal system operation.
  5. If TPM is still missing from the BIOS setup, contact Dell Technical Support for further assistance.

Información adicional

Recommended Articles

Here are some recommended articles related to this topic that might be of interest to you.

Productos afectados

Latitude, XPS, Mobile Workstations
Propiedades del artículo
Número del artículo: 000132757
Tipo de artículo: Solution
Última modificación: 17 sept 2024
Versión:  14
Encuentre respuestas a sus preguntas de otros usuarios de Dell
Servicios de soporte
Compruebe si el dispositivo está cubierto por los servicios de soporte.