Intel Smart Response Technology - Drives not detected during Windows Setup
Step by step Instructions how to resolve drives not being detected in Windows Setup during a OS reinstall in Windows 7/8:
Intel Responsiveness Technology Overview |
||||
---|---|---|---|---|
HDD options requirement |
Description |
BIOS Settings |
Application used to configure |
|
Intel Smart Connect |
1. SSD only 2. mSATA only |
Connect continuously updated while the notebook is on sleep |
Intel Smart Connect: Enabled |
Intel Smart Connect |
Intel Smart Response |
1. HDD + SSD 2. HDD + mSATA |
Cache/Optimize performance 3x It dynamically monitors file, data, and application use, and stores frequently used content on a special partition on the SSD device for faster access |
SATA Operation : ISRT |
Intel Rapid Storage |
Intel Rapid Start |
3. HDD + SSD 4. HDD + mSATA 5. SSD Only 6. mSATA Only |
Provides power savings similar to Windows hibernate state, while improving resume time vs. hibernate by ~2x. |
Intel Rapid Start: Enabled |
Intel Rapid Storage & Rapid Start |
Option 1
1. Change the SATA Operation mode in the BIOS from ISRT to AHCI
2. Boot to the Win 7/8 OS Media via F12 Boot Options
3. Inside Windows Setup, all drives should be detected; Delete all partitions listed. Make sure it shows un-partitioned on all Drives detected. Do not continue, but restart the system
4. Go back to BIOS and change SATA Operation mode from AHCI to ISRT.
5. Boot to the Win 7/8 OS Media via F12 Boot Options
6. Inside Windows Setup, all drives should be detected again; Delete all partitions listed. Make sure it shows un-partitioned on all Drives detected.
7. Continue and complete the Windows Setup process.
8. Reinstall drivers (chipset, nic, video, audio etc…)
9. Install the Intel Rapid Storage Drivers
Option 2
1. Make sure the SATA Operation mode in the BIOS is set to ISRT
2. Boot to the Win 7/8 OS Media via F12 Boot Options
3. Inside Windows Setup, hit "Shift" + "F10" . this will open the command prompt window
4. Enter these commands from the command prompt
· Diskpart
· Listdisk
· Select disk 0
· Clean
· Select disk 1
· Clean
5. The drives should now be detected; Delete all partitions listed. Make sure it shows un-partitioned on all Drives detected
6. Continue and complete the Windows Setup process.
7. Reinstall drivers (chipset, nic, video, audio etc…)
8. Install the Intel Rapid Storage Drivers
Option 3
Download the latest driver for IRST from support website - www.dell.com/support/home?app=drivers - then extract the file to a USB flash drive.
1. Make sure the SATA Operation mode in the BIOS is set to ISRT
2. Boot to the Win 7/8 OS Media via F12 Boot Options
3. Inside Windows Setup, click on "Load Drivers"
4. Insert the flash drive and Browse for the Rapid Storage drivers and click "ok"
5. This will install the IRST drivers and the drives should automatically show
6. Continue and complete the Windows Setup process.
7. Reinstall drivers (chipset, nic, video, audio etc…)
8. Install the Intel Rapid Storage Drivers
Note: These options are system specific, some options might not work on some Consumer systems, Options listed above must be tested one at a time.