Latitude 5404 Rugged Teardown and Removal Guide for Customer Replaceable Units (CRUs)
Resumen: This article provides information about how to safely remove the customer replaceable units (CRUs) in a Latitude 5404 Rugged.
Síntomas
Causa
Not applicable
Resolución
Removal Guide
These guides take you step by step through the safe removal of the customer replaceable unit (CRU) parts of a Latitude 5404 Rugged. CRUs are the parts of the computer that should not need an engineer to remove or replace.
The guides also include figures to reference what is involved.
If these guides do not cover what you are looking to do, then reference your System Manual.
The article below provides information about safe practices to consider before working with electrical equipment.
Removal Instructions
| 1 | Small Phillips head screwdriver | 2 | Plastic Scribe |
| 3 | Small flat head screwdriver |
-
Pre-removal instructions before removing the battery:
-
During installation or removal of any hardware, always ensure that all data is backed up properly.
-
Disconnect any telephone, network, or USB cables from the computer.
-
Disconnect the computer and all attached devices from their electrical outlets.
-
-
Establishing image.
-
Press and hold in the battery release latch (1) and simultaneously pull on the blue mylar tab to slide the battery out of the computer.
-
Complete.
-
Pre-removal instructions before removing the optical drive (CD-ROM/DVD):
-
During installation or removal of any hardware, always ensure that all data is backed up properly.
-
Disconnect any telephone, network, or USB cables from the computer.
-
Disconnect the computer and all attached devices from their electrical outlets.
-
Remove the Battery.
-
-
Establishing image.
-
Remove the two screws on the base of the computer. One screw is located between the service tag label and the corner of the computer. The other is the second screw away from the docking connector. Both screws are on a diagonal line passing through the label.
-
Use something blunt to push the optical drive out and away from the computer.
-
Pull the optical drive from the module bay.
-
Complete.
-
Pre-removal instructions before removing the hard disk drive:
-
During installation or removal of any hardware, always ensure that all data is backed up properly.
-
Disconnect any telephone, network, or USB cables from the computer.
-
Disconnect the computer and all attached devices from their electrical outlets.
-
Remove the Battery.
-
-
Establishing image.
-
Press and hold down the hard drive release latch and simultaneously pull on the bracket handle to pull the hard drive bracket out of the computer.
-
Remove the two screws securing the bracket to the hard drive.
-
Remove the bracket from the hard drive.
-
Complete.
| If you require further assistance, contact Technical Support. | ||
| Contact Us | ||