Omitir para ir al contenido principal
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos

How to boot into the BIOS or the Lifecycle Controller on your PowerEdge Server

Resumen: This article explains how to enter in the System Menu (BIOS) of a PowerEdge Dell Server using the shortcut F2.

Este artículo se aplica a Este artículo no se aplica a Este artículo no está vinculado a ningún producto específico. No se identifican todas las versiones del producto en este artículo.

Síntomas

SLN167315_en_US__1icon Note: This article is part of the Server Tutorials: Support Tools, available here.

To enter the BIOS, press a function <F> key. Which function key to press is dependent upon your specific server. General guidelines are as follows:

  • <F2> Enables you to enter System Setup (BIOS) .
  • <F10> Enables you to enter system services and starts Lifecycle Controller (for iDRAC/Lifecyle Contoller enabled systems)
  • <F11> Enables you to enter Boot Manager.
  • <F12> Enables you to enter PXE Boot.

Press the desired <F> key once every two seconds until you see confirmation on the screen that you are entering the correct mode.
The <F> key menu is in the right of the screen,as show in figure 1.
SLN167315_en_US__21(75)
Figure 1.

Note: On older systems, you may not get confirmation. If you do not receive conformation of the mode on screen, then continue to press the correct key, once every two seconds until the mode is showing on screen.

 

On newer servers, you only need to press <F2> once when you see the Dell Splash screen. You should see confirmation of the boot mode in the upper right-hand corner.


Other BIOS may include the Remote Access Card or PERC controller. The method is the same. The two second rule still applies. You still start at the Dell Splash screen. The only difference is the 2 key combination. The POST of the server will display the needed two-key character required. <Ctrl>+<e> and <Ctrl>+<p> are popular for many Dell implementations.



 
Note: The DRAC can also be accessed by pressing <F2>.

The System Setup Main Menu allows to configure:
 

Option Description
System BIOS Enables you to configure BIOS settings.
 
iDRAC Settings Enables you to configure iDRAC settings.

The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable various iDRAC parameters by using the iDRAC settings utility. For more information about this utility, see Integrated Dell Remote Access Controller User’s Guide at Dell.com/idracmanuals.
Device Settings Enables you to configure device settings (PERC, Network Card)

 

 

 

Causa

-

Resolución

-

Productos afectados

Servers, PowerEdge, iDRAC7 with Lifecycle Controller Version 2.21.21.21, iDRAC8 with Lifecycle Controller Version 2.23.23.21
Propiedades del artículo
Número del artículo: 000176910
Tipo de artículo: Solution
Última modificación: 23 sept 2024
Versión:  7
Encuentre respuestas a sus preguntas de otros usuarios de Dell
Servicios de soporte
Compruebe si el dispositivo está cubierto por los servicios de soporte.