Dit artikel bevat informatie over het instellen van offsetwaarden voor ventilatorsnelheid in iDRAC7 zonder opnieuw op te starten.
PowerEdge servers van de 12e generatie bieden ondersteuning voor het instellen van offsetwaarden voor ventilatorsnelheid om een hogere of lagere luchtstroom te bieden op basis van hardwareconfiguraties.
Momenteel is dit mogelijk door waarden in te stellen in het DRAC-configuratiehulpprogramma dat tijdens POST wordt geopend. Het wijzigen van deze instellingen is op dit moment niet mogelijk via RACADM of GUI.
Tijdelijke oplossing kan worden gebruikt om deze waarden op afstand in te stellen.
Snelheid van de ventilator Offset-instellingen kunnen worden gewijzigd met de opdracht ipmitool. Deze functie wordt ondersteund in de volgende racadm-release voor iDRAC7.
Installeer Dell BMC-tools op een beheerstation en zorg ervoor dat IPMI over LAN is ingeschakeld in de iDRAC-netwerkconfiguratie. (Klik hier om het Dell BMC hulpprogramma te downloaden.)
Voer de opdracht uit om de waarde in te stellen op Lage ventilatorsnelheid:
ipmitool -I lanplus -H ipaddress of idrac -U username -P password raw 0x30 0xCE 0x00 0x09 0x07 0x00 0x00 0x00 0x07 0x00 0x02 0x02 0x02 0x00 0x00
Voer de opdracht uit om de waarde in te stellen op hoge VENTILATORSNELHEID offset:
ipmitool -I lanplus -H ipaddress of idrac -U username -P password raw 0x30 0xCE 0x00 0x09 0x07 0x00 0x00 0x00 0x07 0x00 0x02 0x02 0x02 0x01 0x00
De snelheid van de ventilator verandert onmiddellijk nadat de opdracht is uitgevoerd.
Niet van toepassing
Niet van toepassing