Article Number: 000185631
The article below provides information about safe practices to consider before working with electrical equipment.
Two side-by-side pairs will be treated as a single FlexBay (Figure 1). The backplane consists of two pairs, so it must be replaced on a FlexBay basis.
(Figure 1. FlexBay)
1 | Phillips screwdriver with shaft length × 20cm (+2×200) |
2/3 | 2.0/2.5mm Plus Driver |
The following parts will be required to replace SATA/SAS with PCIe SSD.
Remove the following parts before the replacement.
PCIe SSD Backplane
1 | Thermal Sensor Cable |
2 | Data Cable |
Step to install PCIe SSD Backplane
There are 3 cables to be connected.
1 | Power Cable | 2 | Data Cable |
3 | Thermal Sensor Cable | 4 | A hook to secure Thermal Sensor Cable |
Step to install cables
Step to install M.2 SSD can be learned from the following video:
Install the following parts after the replacement.
Here are some recommended articles related to this topic that might be of interest to you.
Precision 5820 Tower, Precision 7820 Tower
23 Apr 2024
7
How To