Alienware 13 R2, 15 R2 and 17 R3: 7 Beeps

Summary: If a non certified memory module is installed on an Alienware 13 R2, 15 R2 or 17 R3 you may get 7 beeps when starting the system.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.

Check out other resources

Symptoms

Supported Systems:

Alienware 13 R2

Alienware 15 R2

Alienware 17 R3

Solution

Update the BIOS to v.1.2.15 or higher. This can be downloaded from our Drivers Page
Clear the BIOS for recovery:

Steps to reset BIOS on the Alienware 15 R2 and 17 R3
1. Shut down the system
2. Remove the bottom cover
3. Disconnect the battery cable
4. Remove the system memory
  
  Click Here to watch a video on how to remove the memory
5. Locate the CLRP1 Pins
6. Using pliers or a flat head screwdriver touch both pins at the same time
Steps to reset BIOS on the Alienware 13 R2
1. Shut down the system
2. Remove the bottom cover
3. Disconnect the battery cable
4. Remove the system memory
  
  Click Here to watch a video on how to remove the memory
5. Locate the CLRP2 Pins
6. Using pliers or a flat head screwdriver touch both pins at the same time