This article serves as a guide to ensure safe removal of what are considered to be the Customer Replaceable Unit (CRU) parts of a Precision Mobile Workstation 5550 system. (CRUs are the parts of the system that should not need an engineer to remove or replace.)
Dell Precision Mobile Workstation 5550 has a sleek design and essentially no customer replaceable parts. If these guides do not cover what you are looking to do, then you will want to refer to System Manual for your Precision Mobile Workstation 5550.
1 | Small Phillip's head screwdriver | 2 | Plastic Scribe |
3 | Small Flat head screwdriver |
Pre-Removal Instructions Before removing the SD Memory Card:
During installation or removal of any hardware always ensure all data is backed up properly
Disconnect any telephone, network, or USB cables from the computer
Disconnect the computer and all attached devices from their electrical outlets
Press and release the SD card in the slot for it to partially pop out of the side on your system [1]
Grip the card and pull it the rest of the way out of the slot [2]
If you require further assistance, please contact Technical Support
Contact Us |