Nach der Bereitstellung und Konfiguration der Dell EMC Lösung für Microsoft Azure Stack HCI wird der DCBX-Betriebsstatus auf den Netzwerkswitches möglicherweise als "Ausgefallen" angezeigt. Dies kann überprüft werden, indem Sie Folgendes ausführen:
show interfaces tengigabitethernet x/y pfc detail. TOR1#show interfaces tengigabitethernet 1/5 pfc detail Interface TenGigabitEthernet 1/5 Admin mode is on Admin is enabled, Priority list is 3 Remote is disabled Local is enabled, Priority list is 3 Oper status is init PFC DCBX Oper status is Down Reason: Waiting for Peer State Machine Type is Symmetric TLV Tx Status is enabled PFC Link Delay 65535 pause quntams Application Priority TLV Parameters : -------------------------------------- FCOE TLV Tx Status is enabled ISCSI TLV Tx Status is disabled Local FCOE PriorityMap is 0x8 Local ISCSI PriorityMap is 0x0 1581 Input TLV pkts, 8649 Output TLV pkts, 121 Error pkts, 4495543 Pause Tx pkts, 374345 Pause Rx pkts 0 Input Appln Priority TLV pkts, 0 Output Appln Priority TLV pkts, 0 Error Appln Priority TLV Pkts
Als Teil des Bereitstellungsleitfadens für Dell EMC Storage Spaces Direct Ready Nodes empfehlen wir für Infrastrukturen, die RoCE v2 für RDMA mit Mellanox CX4 LX-Adaptern verwenden, DCBX Willing global im Hostbetriebssystem zu deaktivieren und den Netzwerkadapter DCBXMode auf den verantwortlichen Host festzulegen. Bei dieser Konfiguration gibt es keine Downstream-Entität, die die DCBX-Informationen mit dem Dell EMC Netzwerkswitch austauscht, und daher wird der DCBX-Betriebsstatus auf den serverseitigen Ports als inaktiv angezeigt.