部署和配置适用于 Microsoft Azure Stack HCI 的 Dell EMC 解决方案后,您可能会看到网络交换机上的 DCBX 操作状态可能显示为关闭。可以通过运行以下命令进行验证:
show interfaces tengigabitethernet x/y pfc detail. TOR1#show interfaces tengigabitethernet 1/5 pfc detail Interface TenGigabitEthernet 1/5 Admin mode is on Admin is enabled, Priority list is 3 Remote is disabled Local is enabled, Priority list is 3 Oper status is init PFC DCBX Oper status is Down Reason: Waiting for Peer State Machine Type is Symmetric TLV Tx Status is enabled PFC Link Delay 65535 pause quntams Application Priority TLV Parameters : -------------------------------------- FCOE TLV Tx Status is enabled ISCSI TLV Tx Status is disabled Local FCOE PriorityMap is 0x8 Local ISCSI PriorityMap is 0x0 1581 Input TLV pkts, 8649 Output TLV pkts, 121 Error pkts, 4495543 Pause Tx pkts, 374345 Pause Rx pkts 0 Input Appln Priority TLV pkts, 0 Output Appln Priority TLV pkts, 0 Error Appln Priority TLV Pkts
作为 Dell EMC Storage Spaces Direct 就绪节点部署指南的一部分,对于使用 RoCE v2 for RDMA 和 Mellanox CX4 LX 适配器的基础架构,我们建议在主机操作系统中全局禁用 DCBX willing,并将网络适配器 DCBXMode 设置为 Host in charge。使用此配置时,没有下游实体与 Dell EMC 网络交换机交换 DCBX 信息,因此 DCBX 操作状态将在面向服务器的端口上显示为关闭。