These guides take you step by step through the safe removal of what are considered to be the Customer Replaceable Unit (CRU) parts. (CRUs are the parts of the tablet that do not need an engineer to remove or replace on a Latitude 7220EX Rugged Extreme Tablet.) The guides include pictures to reference what is involved.
If these guides do not cover what you are looking to do, and then you must reference your computers manual.
The article below provides information about safe practices that you should be considering before working with electrical equipment.
1 | Small Phillip's head screwdriver | 2 | Plastic Scribe |
3 | Small Flathead screwdriver |
Pre-Removal Instructions Before removing the Battery Cover:
During installation or removal of any hardware always ensure that all data is backed up properly.
Disconnect any telephone, network, or USB cables from the computer.
Disconnect the computer and all attached devices from their electrical outlets.
Lift the handle on the two (2) captive screws on the bottom of the chassis. Loosen both screws.
Slide the cover towards the bottom of the tablet to reveal the battery bay.
Lift the battery cover off of the battery bay and lift it away from the tablet.
Pre-Removal Instructions Before removing the Battery:
During installation or removal of any hardware always ensure that all data is backed up properly.
Disconnect any telephone, network, or USB cables from the computer.
Disconnect the computer and all attached devices from their electrical outlets.
For left-hand side Battery, the battery locking slide is on the outside edge of the battery and tablet.
Slide the latch towards the battery until you see an orange line beside the catch and then slide the catch towards the bottom of the tablet to unlock the battery.
Lift the battery out of the battery bay and lift it away from the tablet.
Pre-Removal Instructions Before removing the Micro-SD Card:
During installation or removal of any hardware always ensure that all data is backed up properly.
Disconnect any telephone, network, or USB cables from the computer.
Disconnect the computer and all attached devices from their electrical outlets.
The micro-SD port is located on the right-hand side of the tablet. Open the door and push the seated micro-SD card further into the reader, it pops out far enough for you to get a grip of it.
Pull the micro-SD card fully out of the slot and tablet.
Pre-Removal Instructions Before removing the Cellular uSIM Card:
During installation or removal of any hardware always ensure that all data is backed up properly.
Disconnect any telephone, network, or USB cables from the computer.
Disconnect the computer and all attached devices from their electrical outlets.
Remove the Batteries.
The uSIM card is located inside the right-hand side battery bay, gently remove the uSIM card cap off of the slot and using a flat pointed scribe push in on the uSIM card for it to pop out so you can pull it the rest of the way out of the tablet.
Pre-Removal Instructions Before removing the Stylus:
During installation or removal of any hardware always ensure that all data is backed up properly.
Disconnect any telephone, network, or USB cables from the computer.
Disconnect the computer and all attached devices from their electrical outlets.
Looking at the tablet from the rear the stylus is located on the top left-hand corner of the tablet. Slide the stylus up and out of the tablet using the groove on the stylus pen.
Contact Us |