文章摘要:本文提供在 Powerconnect 6200 系列交换机上设置堆叠的流程。
以下命令更改接口的模式,然后重新启动交换机。
console#config
console(config)#stack
console(config-stack)#stack-port 1/xg1 stack
console(config-stack)#stack-port 1/xg2 stack
console(config-stack)#end
console#copy running-configuration startup-configuration
console#reload
使用操作说明,将每个交换机更新到最新固件。
关闭交换机电源。对于堆叠中的每个交换机,将其中一条堆叠电缆从交换机上的堆叠端口 1 连接到下一个交换机上的堆叠端口 2。在堆叠的最后一个交换机上,将端口 1 连接到第一个交换机的端口 2。
首先打开所需的主交换机的电源。之后依次一次打开一个交换机的电源,直到每个交换机都打开。
console#show switch 将会显示交换机状态、固件代码和堆叠中的交换机数量。使用此命令验证堆叠。