本文提供将PowerConnect 2800系列交换机重置为没有管理访问的出厂默认值的必要步骤。
如果PowerConnect 2800系列交换机看似没有响应,或无法从Web界面登录,则应在派送更换硬件之前尝试以下过程。
1.将空调制解调器串口电缆连接到交换机,并配置终端仿真器,如下所示:
- 将Baud rate(波特率)设置为9600
- 将data format(数据格式)设置为8 bits(8位),将stop bits(停止位)设置为1,并设置no parity(无奇偶校验)位
- 将flow control(流控制)设置为None(无)
- 选择VT100作为Emulation mode(仿真模式)(此设置的位置将根据您使用的终端仿真器的不同而不同)
Power Connect 2808 没有串行端口。 如果无法访问此交换机,则使用Management Mode(管理模式)针孔按钮将交换机切换为非受控模式,然后返回受控模式以重置默认设置。Power Connect 2800s的默认IP地址为192.168.2.1,默认用户名为“admin”,未分配密码。
2. 登录Startup Menu(启动菜单)
- 关闭交换机,然后再打开交换机。
- 在提示的前2秒内按Esc,以进入Startup menu(启动菜单)。
- 您应看到以下信息:
启动菜单
[1] Download Software(下载软件)
[2] Erase Flash File(擦除刷新文件)
[3] Enter Diagnostic Mode(进入诊断模式)
[4] Set Terminal Baud-Rate(设置终端波特率)
[5] Back(返回)
输入您的选择或按“ESC”退出:
3. 擦除刷新文件并覆盖当前配置:
- 选择选项2 - Erase Flash File(擦除刷新文件)
- 确认操作: Are you sure (Y/N) ?(是否确定(Y/N)?)Y
- 写下刷新文件名称(最多8个字符,若不设置,则按Enter。):config
- 按Enter完成此过程。
提醒: 当前配置文件名为 config。输入此名称对于重置为出厂默认值很关键。
4. 如果继续监视您的终端仿真器,则将提示您使用Dell Easy Setup Wizard(戴尔简易安装向导)。 要跳过安装向导,请输入N并按Enter。 系统将默认为192.168.2.1 255.255.255.0,以管理员身份登录,无密码。
提醒: 执行此过程将清除配置并在非受控模式下启动交换机。要进入Managed Mode(受控模式)并登录交换机,使用回形针按交换机正面的Managed Mode(受控模式)按钮约3秒。 即使您执行Dell Easy Setup Wizard(戴尔简易安装向导),交换机仍将处于非受控状态。