Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

How to configure Port Monitoring / Mirroring on Dell EMC Networking OS9 Switches

Summary: How to configure Port Monitoring / Mirroring on Dell Networking Force10 Switches, How to set up port mirror on Dell Switch, How to set up port monitor on Force10

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

 


This article explains how to set up and verify Port Monitoring (Mirroring) on Dell Networking Force10 Switches.


 

Important things to Know

 

  • ​Port Monitoring is supported on both physical and logical interfaces like virtual area network (VLAN) and port-channel.
  • The monitored (the source) and monitoring ports (the destination) must be on the same switch.
  • In general, a monitoring port should have no ip address and no shutdown as the only configuration.  A monitoring port also may not be a member of a VLAN.
  • There may only be one destination port in a monitoring session.
  • A Port monitoring session can have multiple source statements.
  • One Destination Port can be used in multiple sessions.


 

Configure Port Monitor Session


 

Command

Purpose

Force10# configure

Enter configuration mode.

Force10(conf)# interface te 0/2

Enter the destination port to be used for monitor session.  Confirm that it has no configuration. 

Force10(conf-if-te-0/2)# no switchport
 		 Remove any Layer 2 that may be configured.

Force10(conf-if-te-0/2)# no ip address

Remove any ip address that may be configured.

Force10(conf-if-te-0/2)# no shutdown

Enable the port.

Force10(conf-if-te-0/2)#exit

Leave the destination port interface.

Force10(conf)# monitor session 0

Set up and identify the session number. Range 0 - 65535.

Force10(conf-mon-sess-0)#source te 0/1 destination te 0/2 direction both

Set the source (the port you want to monitor).  Set the destination (the port where you send the monitored packets).  Set the direction (Both/Rx/Tx).


 

Verify Port Monitor Session

 


Force10#show monitor session 0
 
  SessID  Source         Destination         Dir     Mode      Source IP      Dest IP
  ------         ------               -----------             ---       ----           ---------          --------
     0          Te 0/1              Te 0/2             both     Port            N/A              N/A   

 

 

Affected Products

Force10 S60-44T
Article Properties
Article Number: 000118038
Article Type: How To
Last Modified: 21 Feb 2021
Version:  3
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.