Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products

Precision 5820 Tower, Precision 7820 Tower, Precision 7920 Tower NVMe Drives Do Not Work in Legacy Mode

Summary: The NVMe Drives do not work in Legacy Mode on the Precision 5820 Tower, Precision 7820 Tower, and Precision 7920 Tower.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.

Symptoms

NVMe Drives disappear or do not work when in Legacy Mode.

Affected Platforms

  • Precision 5820 Tower
  • Precision 7820 Tower
  • Precision 7920 Tower

Cause

The Intel Volume Management Device (VMD) Technology (also known as Intel® Virtual RAID on CPU or vROC) does not support Legacy Mode. These drives will only show up attached to the controller when in UEFI Mode.

Resolution

Go into BIOS and disable the VMD controllers so that the platform uses the native NVMe controllers and NVMe Drivers on the operating system.

  1. Boot into BIOS setup
  2. Navigate to System Configuration an Intel VMD Technology and change the computer from Auto to Disabled and clear all the PCIE boxes on the same page (Figure 1).
    System Configuration

    Figure 1: System Configuration

  3. Click apply, OK, and then Exit.

Hot plug would no longer be supported on these drives when used in this mode.

Affected Products

Precision 5820 Tower, Precision 7820 Tower, Precision 7920 Tower
Article Properties
Article Number: 000144064
Article Type: Solution
Last Modified: 02 Oct 2023
Version:  6
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.