Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

如何为Dell Networking Force10交换机上的巨型帧配置MTU（最大传输单元）

Summary: 如何在戴尔交换机上配置巨型帧, 如何在 Force10 上设置巨型帧, 如何在 Dell Force10 交换机上配置 MTU

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions



本文介绍如何为Dell Networking Force10交换机上的巨型帧配置MTU（最大传输单元）。

 

如何配置MTU

 

MTU在接口级别设置。

 

命令 参数
FTOS# configure 进入全局配置模式。
FTOS(conf)# interface te 0/1
FTOS(conf)# interface range te 0/1 - 24		 输入需要MTU集的接口或接口范围。
FTOS(conf-if-range-te-0/1-24)# mtu 12000 设置MTU的值。默认值为1554。值的范围为594至12000
有些以前型号的值范围为594至9252。
FTOS(conf-if-range-te-0/1-24)# no mtu 将指定端口返回至默认 MTU 1554。


 

验证MTU状态



FTOS#show interfaces te 0/1
TenGigabitEthernet 0/1失效，线协议失效
硬件为DellEth，地址为00:01:e8:8b:18:bb
当前地址为00:01:e8:8b:18:bb
可插拔介质不存在
接口索引为17368066
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP客户端ID：0001e88b18bb
MTU 12000 bytes, IP MTU 11982 bytes    

Affected Products

Force10 MXL Blade, Force10 S2410-01-10GE-24P, Force10 S2410-01-10GE-24CP, Force10 S25-01-GE-24P, Force10 S25-01-GE-24T, Force10 S25-01-GE-24V, Force10 S50-01-GE-48T-V, Force10 S50-01-GE-48T, PowerSwitch S4810P, PowerSwitch S5000, Force10 S50P , Force10 S55T, Force10 S60-44T, PowerSwitch S6000, Force10 Z9000, Dell Networking Z9500 ...
Article Properties
Article Number: 000102843
Article Type: How To
Last Modified: 21 Feb 2021
Version:  3
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.