Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us
Some article numbers may have changed. If this isn't what you're looking for, try searching all articles. Search articles

How to boot into the BIOS or the Lifecycle Controller on your PowerEdge Server

Summary: This article explains how to enter in the System Menu (BIOS) of a PowerEdge Dell Server using the shortcut F2.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Symptoms

SLN167315_en_US__1icon Note: This article is part of the Server Tutorials: Support Tools, available here.

To enter the BIOS, press a function <F> key. Which function key to press is dependent upon your specific server. General guidelines are as follows:

  • <F2> Enables you to enter System Setup (BIOS) .
  • <F10> Enables you to enter system services and starts Lifecycle Controller (for iDRAC/Lifecyle Contoller enabled systems)
  • <F11> Enables you to enter Boot Manager.
  • <F12> Enables you to enter PXE Boot.

Press the desired <F> key once every two seconds until you see confirmation on the screen that you are entering the correct mode.
The <F> key menu is in the right of the screen,as show in figure 1.
SLN167315_en_US__21(75)
Figure 1.

Note: On older systems, you may not get confirmation. If you do not receive conformation of the mode on screen, then continue to press the correct key, once every two seconds until the mode is showing on screen.

 

On newer servers, you only need to press <F2> once when you see the Dell Splash screen. You should see confirmation of the boot mode in the upper right-hand corner.


Other BIOS may include the Remote Access Card or PERC controller. The method is the same. The two second rule still applies. You still start at the Dell Splash screen. The only difference is the 2 key combination. The POST of the server will display the needed two-key character required. <Ctrl>+<e> and <Ctrl>+<p> are popular for many Dell implementations.



 
Note: The DRAC can also be accessed by pressing <F2>.

The System Setup Main Menu allows to configure:
 

Option Description
System BIOS Enables you to configure BIOS settings.
 
iDRAC Settings Enables you to configure iDRAC settings.

The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable various iDRAC parameters by using the iDRAC settings utility. For more information about this utility, see Integrated Dell Remote Access Controller User’s Guide at Dell.com/idracmanuals.
Device Settings Enables you to configure device settings (PERC, Network Card)

 

 

 

Cause

-

Resolution

-

Affected Products

Servers, PowerEdge, iDRAC7 with Lifecycle Controller Version 2.21.21.21, iDRAC8 with Lifecycle Controller Version 2.23.23.21
Article Properties
Article Number: 000176910
Article Type: Solution
Last Modified: 23 Sept 2024
Version:  7
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.