This article covers how to install Dell Data Security Endpoint Security Suite Enterprise for Linux.
Affected Products:
Dell Endpoint Security Suite Enterprise for Linux
Affected Versions:
v1.0.0 and later
Affected Operating Systems:
Linux
The installation process for Dell Data Security Endpoint Security Suite Enterprise for Linux is handled by using command line.
- Open Terminal.
- In Terminal, type
sudo tar –xvf '/FilePathA/DellESSE.tar.gz' –C /FilePathB
and then press Enter.
Note:
- In the above example:
- FilePathA is the path where the tar.gz exists.
- FilePathA example = /home/admin/Desktop/Downloads/
- FilePathB is the path where the tar.gz is being extracted to.
- FilePathB example = /home/admin/Desktop/ESSE
- Commands are case-sensitive.
- The example paths may differ in your environment.
- Type
sudo 'filepath/install.sh'
from the extracted installer package into Terminal and then press Enter.
- Populate the password for the account being used and then press Enter.
- Populate the IP or DNS of the Dell Security Management Server and then press Enter.
- Populate the port of the Dell Security Management Server’s core server service and then press Enter.
Note: By default, the core server service runs on 8888.
- Press Y when prompted to install the DellESSE package and its dependencies and then press Enter.
- If prompted for fingerprint approval, press Y. Otherwise, go to Step 9.
- Press Y to install the CylanceDellATPPlugin package and then press Enter.
- Press Y to install the DellAdvancedThreatProtection package and then press Enter.
- Once installation is complete, type
Exit
and press Enter.
To contact support, reference Dell Data Security International Support Phone Numbers.
Go to TechDirect to generate a technical support request online.
For additional insights and resources, join the Dell Security Community Forum.