Dell EMC Unity: Arrays's own FC Port WWNs visible in the initiators tab in Unisphere after upgrade to 4.4 (User Correctable)

Upgrade of Unity to 4.4.x

The  user may see the array's own FC port WWNs under host initiators tab in Unisphere after the upgrade of the Unity to 4.4.1.
Deleting the WWN from the initiator tab doesn't wors as the initiators will reappear after the job completes.

Fig 1 shows the FC port information in the GUI.

Before Upgrade:


Below is the Initiator tab in Unity GUI where the FC port WWNs are visible these highlighted entries were not visible before the unity had upgraded to 4.4.1

After upgrade:

 

This issue was introduced in 4.4.0 due to 2-way NDMP feature.
The Unity identifies the array's own FC port as targets.

Fix will be included in upcoming Unity OE release 4.5 due late January

Dell Unity 300, Dell EMC Unity 300F, Dell EMC Unity 350F, Dell EMC Unity 400, Dell EMC Unity 400F, Dell EMC Unity 450F, Dell EMC Unity 500, Dell EMC Unity 500F, Dell EMC Unity 550F, Dell EMC Unity 600, Dell EMC Unity 600F, Dell EMC Unity 650F , Dell EMC Unity Family |Dell EMC Unity All Flash, Dell EMC Unity Family, Dell EMC Unity Hybrid ... View More View Less