Zu den Hauptinhalten
Abmelden

Willkommen bei Dell

Mein Konto
  • Bestellungen schnell und einfach aufgeben
  • Bestellungen anzeigen und den Versandstatus verfolgen
  • Profitieren Sie von exklusiven Prämien und Rabatten für Mitglieder
  • Erstellen Sie eine Liste Ihrer Produkte, auf die Sie jederzeit zugreifen können.
  • Verwalten Sie mit der Unternehmensverwaltung Ihre Dell EMC Seiten, Produkte und produktspezifischen Kontakte.
Anmelden Konto erstellen Premier-Anmeldung Anmeldung beim Partnerprogramm
Kontakt

Ihr Warenkorb bei Dell.com

Artikelnummer: 000141265

Charging and Turning on the Dell Venue 8 Pro (3845) Tablet

Zusammenfassung: How to charge and Turn on the Dell Venue 8 Pro Tablet.

Dieser Artikel wurde möglicherweise automatisch übersetzt. Wenn Sie eine Rückmeldung bezüglich dessen Qualität geben möchten, teilen Sie uns diese über das Formular unten auf dieser Seite mit.

Artikelinhalt

Symptome

Turning on the tablet

To turn the tablet on, press and hold the power button (located on the top edge of the tablet in portrait mode, on the right-hand side) for three to five seconds.

Ursache

 

Lösung

Notes:
  1. You may need to charge the Venue 8 Pro (3845) tablet before you use it, as it is possible for the tablet to discharge during shipping. When the tablet is charging and the LED flashes amber, the battery is at a critical level and does not have enough charge to power on. If the power button is pressed during this state, the LED will turn on for 3 seconds and then turn off. Continue charging the tablet.
  2. The micro-USB connector on the Venue 8 Pro (3845) can support data transfer or AC power but not both at the same time. When it is connected to a USB port on a computer, it automatically switches to data transfer mode and will not charge the battery. To charge the device, always use the AC power adapter with the USB-to-micro-USB cable supplied with the device. The micro-USB port is located on the upper right edge of the tablet (Figure 1 and 2).
  3. Normally, the battery will require about 4 hours to fully charge. The charge status can be checked from within the operating system.

SLN293681_en_US__1I_Tablet_Venue_8_Pro_3845_Charging_Port_Location

SLN293681_en_US__21380813937639.venue8pro_microusb
Figure 1 and 2: Charging Port Location

LED Status Indicators

State What it means
Solid White The battery is charging.
Solid Amber The battery is at low level with the tablet is on or in a connected standby state - the screen is off but the tablet is still turned on.
Off The battery is not charging or the battery is fully charged.
Flashing Amber The battery is at a critical level and does not have enough charge to power on. If the power button is pressed during this state, the LED will turn on for 3 seconds and then turn off. Continue charging the tablet.
Table 1: LED State
Note: Normally, the battery will require about 4 hours to fully charge. The charge status can be checked from within the operating system.
 
Caution: Charge the battery in an ambient temperature of 0 degrees Celsius (32 degrees Fahrenheit) to 35 degrees Celsius (95 degrees Fahrenheit). Use only the power adapter provided for charging the tablet. Using other power adapters or micro-USB cables may cause damage to your tablet.

Tablet charging troubleshooting steps:

The best way to troubleshoot this issue is to setup a test station with a known good tablet, AC power adapter and Micro-USB cable, if available.

  1. Check the AC power adapter that came with the tablet by using a known good Micro-USB cable with known good tablet, if available.
  2. Check the wattage displayed in the tablet BIOS, if the correct wattage is shown (10 watts) then no further action are needed, continue to use the same adapter and cable to charge your tablet.
    To get into the BIOS, perform the following steps.
    1. With the tablet off, press the Power button and the Volume down button until you reach the BIOS screen.
  3. When the BIOS shows less than 10 watts, unplug the AC adapter from the wall for 10-15 seconds and then reconnect.
  4. Check the BIOS wattage again. When it still shows less than 10 watts, try another AC adapter if available, when using another AC adapter and it still shows less than 10 watts, then try another USB to micro USB cable if available. If another cable is not available, try gently moving the micro USB connector where it attaches to the tablet and note any changes in the wattage. Inspect the cable (especially the Micro USB end) and the Micro USB connector on the tablet. Replace the affected component. If the connector on the tablet is damaged, the system will require service to replace the USB daughterboard to resolve.

Weitere Informationen

 

Videos

 

Artikeleigenschaften

Betroffenes Produkt

Venue 3845 Pro

Letztes Veröffentlichungsdatum

01 März 2021

Version

4

Artikeltyp

Solution

Zurück zum Anfang