Latitude Rugged Tablets: A guide to various carry methods

The following article is a guide to the installation of the various methods provided to carry the Dell 12 Rugged Tablets.

Table of Contents:

1. Introduction
2. Rigid Handle Installation
3. Soft Handle Installation
4. Chest Harness Installation
5. Shoulder Strap Installation

Introduction

This article shows the various carry methods supplied for the Latitude 12 Rugged Tablets and the installation method to fit them to the tablet. These items are optional extras.

• Latitude 7202 Rugged Tablet
• Latitude 7212 Rugged Extreme Tablet
• Latitude 7220 Rugged Extreme Tablet

Back to Top

Rigid Handle Installation

The rigid handle is a solid piece of ruggedized plastic that attaches to the top of the Tablet:

Note: Ensure the Stylus is removed from the tablet before you attempt to fit the handle. The stylus will slide into the handle instead, once it's fitted.

1. Locate the rigid handle to the two (2) accessory connection points on the top edge of the Tablet. Use a screwdriver to lock the handle in place.

2. Ensure the handle is fitted with the space for the stylus accessible from the right-hand side of the tablet.

Back to Top

Soft Handle Installation

The soft handle is a flexible piece of ruggedized plastic that attaches to the top of the Tablet:

1. Locate the soft handle to the two (2) bars on either side of the top edge of the Tablet.

2. Pass the thread loop on the end of the soft handle through the bar on the side of the tablet.

3. Pull the thread loop back up through the bracket on the end of the soft handle and hook the end of the loop over the hook in the bracket and pull it tight.

Back to Top

Chest Harness Installation

The chest harness is a flexible piece of ruggedized plastic that attaches to each corner of the Tablet:

1. Locate the ends of the chest harness to the four (4) bars on each corner of the Tablet.

2. Pass the thread loop on the end of each harness strap through the bar on each corner of the tablet.

3. Pull the thread loop back up through the bracket on the end of the strap and hook the end of the loop over the hook in the bracket and pull it tight.

Back to Top

Shoulder Strap Installation

The shoulder strap is a flexible piece of ruggedized plastic that attaches to the Tablet:

1. Locate the strap to two (2) bars on either side of one of the edges of the Tablet.

Note: You can locate the strap to whichever edge of the tablet suits your needs best:

(Figure.1 Horizontal)

(Figure.2 Vertical)

2. Pass the thread loop on the end of the strap through the bar on the side of the tablet you've chosen.

3. Pull the thread loop back up through the bracket on the end of the strap and hook the end of the loop over the hook in the bracket and pull it tight.

Back to Top