Artikelnummer: 000121440

How to configure MAC based port security on Dell N2000, N3000, and N4000 series switches.

Zusammenfassung: Dell EMC Networking N-Series configuring MAC based port security on switches.

Dieser Artikel wurde möglicherweise automatisch übersetzt. Wenn Sie eine Rückmeldung bezüglich dessen Qualität geben möchten, teilen Sie uns diese über das Formular unten auf dieser Seite mit.

Artikelinhalt

Weisungen

Article Summary: This article shows how to configure MAC based port security on Dell N Series switches

How to enable MAC based port security on the N Series Switch
How to statically add MAC address to an Interface
How to configure a maximum amount of allowed MAC addresses
How to configure the maximum limit of dynamically learned mac addresses on a specific interface

How to enable MAC based port security on the N series switch

Command	Parameters
console>enable	Enter enable Privilege Exec mode.
console#config	Enter configuration mode.
console(config)#switchport port-security	Enable port security globally on the switch.
console(config)#interface gi1/0/5	Enter specific interface that needs port security.
console(config-if-gi1/0/5)#switchport port-security	Enable port security on the interface level.

Note: When port security is enabled on an interface, all dynamic MAC addresses learned on that port are removed, and the port re-learns any MAC addresses on that interface.

How to statically add MAC addresses to an interface

Command	Parameters
console#config	Enter configuration mode.
console(config)# mac address-table static c2f3.220a.12f4 vlan 1 interface gi1/0/5	This adds the MAC address c2f3.220a.12f4 to the MAC table for interface gi1/0/5.
console(config)#no mac address-table static c2f3.220a.12f4 vlan 1 interface gi1/0/5	Add "no" to the beginning of the command to remove the MAC address.

How to configure a maximum amount of allowed Static MAC addresses

Command	Parameters
console#config	Enter configuration mode.
console(config)#interface gi1/0/5	Enter specific interface that needs port security.
console(config-if-Gi1/0/5)#switchport port-security maximum 3	Sets the max limit of static MAC addresses to 3. Range is <0-100> Default is 100.

Note: To clear dynamically learned MAC addresses from a port, you must perform the following example command.
console#clear mac address-table dynamic interface gi1/0/5

Note: By default when port security violations occur, the port discards any frames on that interface originating from violating MAC addresses. The port is not shut down. If you are wanting the port to actually shut down you will need to add this command to the specific interfaces that require that feature:
(config-if-Gi1/0/5)#switchport port-security violation shutdown :

How to configure the maximum limit of dynamically learned mac addresses on a specific interface

Command	Parameters
console#config	Enter configuration mode.
console(config)#interface gi1/0/5	Enter specific interface that needs port security.
console(config-if-gi1/0/5)#switchport port-security dynamic 0	This example uses 0 as you would normally want the port not to learn macs dynamically. Range is <0-600> Default is 100.

Artikeleigenschaften

Betroffenes Produkt

PowerSwitch N2000 Series, PowerSwitch N3000 Series, PowerSwitch N4000 Series

Letztes Veröffentlichungsdatum

21 Feb. 2021

Version

Artikeltyp

How To

Zurück zum Anfang

Willkommen

Willkommen bei Dell