Přeskočit na hlavní obsah
  • Vkládejte objednávky snadno a rychle
  • Zobrazit objednávky a sledovat stav expedice
  • Vytvořte a přistupujte k seznamu svých produktů

Latitude 5480: Teardown removal guide for customer replaceable units (CRUs)

Shrnutí: These guides take you step-by-step through the safe removal of the Customer Replaceable Unit (CRU) parts of a Latitude 14 5480 laptop. (CRUs are the parts of the laptop that do not need an engineer to remove or replace.) The guides include pictures referencing what is involved. ...

Tento článek se vztahuje na Tento článek se nevztahuje na Tento článek není vázán na žádný konkrétní produkt. V tomto článku nejsou uvedeny všechny verze produktu.

Příznaky

Table of Contents:

  1. CRU Removal Guide
  2. Removal Instructions

 

Removal Guide

 

If these guides do not cover what you are looking to do, then you must reference your System Manual.

The article below provides information about safe practices to consider before working with electrical equipment.

Příčina

Removal Instructions

 

 

Recommended tools

1 Small Phillip's head screwdriver 2 Plastic Scribe
3 Small Flat head screwdriver    
 
Note: Be aware that using a large Phillips or Flat Head screwdriver may result in damage to the head of the screws. This would make their removal impossible without specialty tools that are not available to our onsite engineers.

 

  1. Pre-Removal instructions before removing the Base Cover:

    1. During installation or removal of any hardware always ensures that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

  2. To remove the base cover, turn the computer onto it is back cover. Loosen the Eight (8) captive screws that secure the cover to the computer. [1]

Base Cover 1

  1. Using a Plastic scribe or similar tool, pry the cover up from the rear edge of the computer. [2]

  2. Lift the base cover up and away from the computer.

Base Cover 2

 

  1. Pre-Removal instructions before removing the Battery:

    1. During installation or removal of any hardware always ensures that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Remove the Base Cover.

  2. To remove the battery, disconnect the battery cable from the connector on the Motherboard. [1]

Battery

  1. Remove the captive screw that secures the battery to the computer. [2]

  2. Lift the battery up and away from the computer. [3]

 

  1. Pre-Removal instructions before removing the Keyboard Trim:

    1. During installation or removal of any hardware always ensures that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Remove the Base Cover, and Battery.

  2. Using a plastic scribe or similar tool, pry the keyboard trim up along the top edge of the keyboard [1]. Lift it up and away from the computer. [2]

Keyboard Trim

 

  1. Pre-Removal instructions before removing the Keyboard:

    1. During installation or removal of any hardware always ensures that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Remove the Base Cover, Battery, and Keyboard Trim.

  2. Lift the keyboard cable latch and remove the keyboard cable from the connector.

Keyboard 1

  1. Remove the five (5) screws that secure the keyboard to the computer. [1]

Keyboard 2

  1. Using a plastic scribe or similar tool, pry the keyboard up from the touchpad edge.

  2. Slide the keyboard towards the front of the computer and lift up and away from the computer. [3]

Latitude 5480 Keyboard Removal - Duration 1:29 - English Only

 

  1. Pre-Removal instructions before removing the memory module:

    1. During installation or removal of any hardware always ensures that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Remove the Base Cover, and Battery.

  2. To remove the memory module, pull the securing tabs away from the middle of the module, until the module appears at a 45-degree angle. [1]

Memory 1

  1. Lift the module up and away from the motherboard. [2]

Note: Repeat Steps 2 and 3 for however many additional memory modules located in the computer.
 

Latitude 5480 Memory Removal - Duration 0:54 - English Only

 

  1. Pre-Removal instructions before removing the solid state drive (SSD):

    1. During installation or removal of any hardware always ensures that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Remove the Base Cover, and Battery.

  2. To remove the SSD, remove the SSD bracket from the SSD card.

  3. Peel off the adhesive tape that secures the SSD card. [1]

SSD

  1. Remove the screw that secures the SSD to the computer. [2]

  2. Slide the card towards the front of the computer and lift out of the computer once clear of the card connector. [3]

Note: This is an optional part and must be selected at the point of purchase.

 

  1. Pre-Removal instructions before removing the Hard Disk Drive (Hard Drive):

    1. During installation or removal of any hardware always ensures that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Remove the Base Cover, and Battery.

  2. To remove the Hard Drive assembly, disconnect the hard drive cable from the hard drive connector on the motherboard.

  3. Remove the screws that secure the Hard Drive assembly to the company.

  4. Lift the drive up and away from the computer.

Latitude 5480 Hard Drive Removal - Duration 1:23 - English Only

 

  1. Pre-Removal instructions before removing the WiFi, Wireless Local Area Network (WLAN) Card:

    1. During installation or removal of any hardware always ensures that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Remove the Base Cover, and Battery.

  2. To remove the WLAN card, remove the retaining screw from the edge of the card. [1]

WLAN

  1. Remove the metal tab covering the WLAN antenna cables. [2]

  2. Disconnect the antenna cables from the WLAN card connectors. These are pop stud connectors and lift off with your thumbnail or plastic scribe. [3]

  3. Lift the card up at a 45-degree angle and pull out and away from the connector on the computer. [4]

Latitude 5480 WLAN Card Removal - Duration 1:03 - English Only

 

  1. Pre-Removal instructions before removing the Cellular, 3G, Wireless Wide Area Network (WWAN) Card:

    1. During installation or removal of any hardware always ensures that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

    4. Remove the Base Cover, and Battery.

  2. To remove the WWAN card, follow the same steps as with the WLAN card.

Note: This is an optional part and must be selected at the point of purchase.

 

  1. Pre-Removal instructions before removing the Subscriber Identity Module (SIM) Card:

    1. During installation or removal of any hardware always ensures that all data is backed up properly.

    2. Disconnect any telephone, network, or USB cables from the computer.

    3. Disconnect the computer and all attached devices from their electrical outlets.

  2. Locate the SIM card slot on the rear of your computer.

  3. Insert a straightened paperclip or a SIM card removal tool in the pinhole. [1]

SIM

  1. Pull the SIM card tray out and remove the card from the tray. [2]

Note: This is an optional part and must be selected at the point of purchase.

Řešení


If you require further assistance, contact technical Support.
  Contact Us  

Dotčené produkty

Latitude 5480/5488
Vlastnosti článku
Číslo článku: 000125760
Typ článku: Solution
Poslední úprava: 04 Oct 2023
Verze:  7
Najděte odpovědi na své otázky od ostatních uživatelů společnosti Dell
Služby podpory
Zkontrolujte, zda se na vaše zařízení vztahují služby podpory.