In this video, we show how to replace the OCP on a PowerEdge C6620 before moving the OCP.
Read through and follow the safety guidelines to protect your system from potential damage and ensure your personal safety. For more information about safety guidelines, see the C6620 service manual at Dell.com/Support.
In order to remove the OCP, you must first remove the expansion card riser and riser blink to remove expansion card riser one Remove the three screws to secure the riser to the chassis, then lift the riser from the connector on the system board to remove the riser to blink,
Remove the four screws, securing it to the chassis, then lift it out of the chassis to remove the OCP card, open the blue latch to disengage it, push the card towards the rear of the system and disconnect it from the system board.
To install the OCP card, slide the OCP card into the slot on the system, push the card to see the connector on the system board, then close the latch to lock the OCP in place to install the riser to blank, align the blank with a slot on the chassis and lower into place, then tighten the screws, the secure the blank to the chassis to install expansion card riser one.
Align the riser with a slot on the chassis and lower until firmly seated, then tighten the three screws, the secure the riser to the chassis. For more information or support, visit Dell.com/Support.