How to Replace a BOSS Carrier and M.2 NVMe SSD in a PowerEdge R770

This video demonstrates the process of removing and installing a BOSS Carrier and M.2 NVMe SSD in a PowerEdge R770.

In this video, we show a replace a boss carrier and m.2 NVMe SSD in a PowerEdge R770. Before removing the BOSS carrier, read through and follow the safety guidelines to protect your system from potential damage and ensure your personal safety. For more information about safety guidelines, see the PowerEdge R770 service manual at dell.com/support.

To remove the BOSS carrier, pull open the retention latch, then slide out the carrier. To remove the m.2 NVMe SSD, loosen the two captive screws on the cover, then tilt the cover and remove it. Lift the SSD at an angle and remove it from the connector on the carrier. Note, when replacing the SSD, be sure to replace any existing thermal pads with new ones.

To install the m.2 NVMe SSD, align it at an angle with the connector and slide it in. Place the cover on the carrier and tighten the two captive screws to secure it in place. To install the BOSS carrier, slide it into the slot and close the latch to lock it into place. For more information or support about the PowerEdge R770, visit dell.com/support.