How to Replace Left Control Panel for PowerEdge XE9640

This video will demonstrate the replacement procedure of the left control panel for the PowerEdge XE9640.

Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.

Removing the left control panel
Using the Phillips 1 screwdriver, remove the screws that secure the left control panel and the cable cover to the system.
Disconnect the control panel cable from the connector on the system board.
Holding the cable, slide the left control panel out of the system.
NOTE: Observe the routing of the cable as you remove the left control panel from the system.

Installing the left control panel:
Align and slide the left control panel in the slot on the system.
Route the left control panel cable through the side wall of the system.
Align and slide the left control panel cable cover in the slot on the system.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
Using the Phillips 1 screwdriver, tighten the screws to secure the left control panel and the cable cover to the system.
Connect the left control panel cable to the connector on the system board .

Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.