How to Replace the Serial and Network module in a PowerEdge R670
Опубликовано Jul 26, 2024
This video demonstrates the process of removing and installing the Serial and Network module in a PowerEdge R670.
In this video, we show how to replace the serial and network module in a PowerEdge R670. Before removing the serial and network module, read through and follow the safety guidelines to protect your system from potential damage and ensure your personal safety. For more information about safety guidelines, see the PowerEdge R670 service manual at dell.com/support.
In order to remove the module, you first need to remove the cover and drive backplane cover. To remove the cover, rotate the lock counter clockwise to unlock it, lift the latch to release the cover, then remove it from the system.
To remove the drive backplank cover, slide it towards the back of the system and remove. To remove the serial and network module, disconnect and unroute the serial and network data cable. Remove the two screws securing the module in place, then slide it out of the system.
To install the serial and network module, slide it into the system and secure it using 2 screws. Then route and connect the cable As well as any other disconnected cables. To install the backplane cover, align it on the system and slide it forward into place.
To install the cover, align and place it on the system. Lower the latch, then rotate the lock clockwise to secure the cover. For more information or support about the PowerEdge R670, visit dell.com/support.