How to replace the IDSDM on a Dell EMC PowerEdge T350

This video shows how to remove and install the IDSDM on a Dell EMC PowerEdge T350.

This video shows how to replace the IDSDM on a PowerEdge T350. Before you begin, power off the system, and disconnect all the attached peripherals. Ensure that you always use ESD protection when working inside the system. For more information about safety guidelines, see the Service manual at: Dell.com/poweredgemanuals. To begin, first remove the system cover. To do this, rotate the lock on top of the system cover to unlock position.

Lift the latch to disengage the cover from the system. Then lift the system cover off. Then by holding the air shroud, lift the air shroud out of the system. To remove the IDSDM, holding the pull tab lift the IDSDM out of the connector on the system board. To replace the IDSDM, align the IDSDM with the slots on the system board and press until firmly seated. Then replace the air shroud, lower the air shroud until it is firmly seated.

Finally, replace the system cover. To do this, first place the cover into its position on the system. Lower the latch to engage the cover into the system. Then rotate the lock on top of the system cover to lock position. You have replaced the IDSDM on a PowerEdge T350. If you need more information or assistance, go to dell.com/poweredgemanuals.