In this video, we demonstrate how to replace a memory module in an Inspiron 14 5440 with an aluminum chassis. Ensure that you always use ESD protection when working inside the computer. Disconnect all the attached peripherals and enter service mode. To enter service mode press and hold the B key on the keyboard and then press the power button. Now the computer will boot up and the owner tag information is displayed on the screen. Press any key to proceed. The computer will emit three short beeps and shut down.
Now to begin. Loosen the two captive screws and then remove the five screws to secure the base cover to the palm-rest and keyboard assembly. Next, use a plastic scribe to pry open the base cover starting from the recesses near the hinges. Continue prying along the other sides to release the base cover and remove it. To remove the memory module, gently lift the mylar to access the memory module and pull the retention clips away until it pops up slightly.
Hold the module by the edges and carefully remove it from the slot on the system board. Repeat these steps for removing the second memory module. If installed To install the memory module lift the mylar to access the memory module slot. Now carefully align the notch on the memory module with the tab on the slot on the system board, and slide it in at an angle. Hold the memory module by its edges and gently press down on it until the retention clips click into place.
Repeat these steps for any additional memory modules you are installing. Align the base cover with a palm-rest and keyboard assembly and snap it into place. Replace the five screws and then tighten the two captive screws to secure the base cover to the palm-rest and keyboard assembly. Once the computer is fully assembled, connect the power adapter and press the power button to turn on the computer and exit service mode.
Please note the computer will only power on if the power adapter is connected. For more information about the Inspiron 14 5440, visit dell.com/support.
