How to replace the cabled power supply on a Dell EMC PowerEdge R250

This video shows how to remove and install the cabled power supply on a Dell EMC PowerEdge R250.

This video shows how to replace cabled power supply on a PowerEdge R250 Before you begin, Power off the system and disconnect all the attached peripherals. Ensure that you always use ESD protection when working inside the system For more information about safety guidelines, see the Service s manual at: Dell.com/PowerEdgeManuals.

To begin, first remove the system cover to do this if the latch lock is in lock position rotate it to the unlock position lift the latch to disengage the cover from the system, then lift the system cover off For air shroud, hold the air shroud at both ends and lift it out of the system. Now to remove the cabled power supply. First you must disconnect the power and signal cable from the system board Now remove the screw on the cabled power supply And slide it towards the front of the system.

Now lift the cabled power supply out of the system. To replace the cabled power supply Place the cabled power supply into the system and then slide in towards the back of the system. Now replace the screw on the cabled power supply You can now connect the power and signal cable to the connector on the system board. Now align the slot on the air shroud with standoff on the system And lower the air shroud holding it at both the ends until it is firmly seated.

Finally, replace the system cover by placing the cover into its position on the system lower the latch to engage the cover on to the system, Then rotate the lock to the locked position You have replaced the cabled power supply on a PowerEdge R250 If you need more information or assistance, go to dell.com/poweredgemanuals.