How to Replace the Fan for PowerEdge C6220

This video will will replacement procedure of an fan for the PowerEdge C6220.

WARNING: Do not attempt to operate the system without the cooling fans.

WARNING: The cooling fan can continue to spin for some time after the system has been powered down. Allow time for the fan to stop spinning before removing it from the system.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

Removing a Cooling Fan:
It is recommended to turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet.
Open the system. See “Opening the System” 
Disconnect the fan’s power cable from the power distribution board.
Note : the routing of the cable through the cable tie as you remove them from the system. You must route these cables properly when you replace them to prevent the cables from being pinched or crimped.
Directly lift the cooling-fan cage out of the chassis.
Disconnect the fan cable from the fan connector on the cooling-fan cage.
Lift the cooling fan with the sponge out of the cooling-fan cage.

Installing a Cooling Fan
Align the cooling fan with sponge and slide it in the cooling-fan cage until the cooling fan is firmly seated.
Connect the fan cable to the connector on the cooling-fan cage.
Align the cooling-fan cage with the locating pins on the chassis and place it into the chassis until it’s firmly seated in place.
Connect the fan’s power cable to the connector on the power distribution board.
Close the system. See “Closing the System”.

Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.