In this video, we show how to replace the intrusion switch on a PowerEdge R760xs. Before removing the intrusion switch, read through and follow the safety guidelines to protect your system from potential damage and ensure your personal safety. For more information about safety guidelines, see the R760xs Service Manual at Dell.com/Support. In order to remove the intrusion switch, you must first remove the cover and air shroud.
To remove the cover: Use a screwdriver to rotate the lock counterclockwise to the unlocked position. Next, lift the release latch until the system cover slides back. Then lift the cover from the system. To remove the air shroud: Hold the air shroud at both ends and lift it out of the system. To remove the intrusion switch: Disconnect the power cable from the system board to get access to the intrusion switch cable. Next, disconnect the intrusion switch cable from the system board.
Loosen the screw on the intrusion switch. Then lift it out of the system. To install the intrusion switch: Align and lower it into the system. Then tighten the screw. Next, connect the intrusion switch cable to the system board and reconnect the power cable to the system board. To install the air shroud: Align it with the chassis and lower until firmly seated. To install the cover:
Align the system cover with the guide slots on the system and place it on the system. Next, close the system cover release latch. Finally, using a screwdriver, rotate the lock clockwise to the locked position. For more information or support, visit Dell.com/Support.
