Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
For more information, see the Rail Installation Guide relevant to your rail solutions at PowerEdge Manuals.
Remove the system cover.
Remove rear GPU fan(s).
Remove the GPU fan cage.
CAUTION: Ensure that two people operate the GPU tray due to its heavy weight.
Removing the GPU tray:
Using a Phillips 2 screwdriver, release ten capture screws on both side of the chassis.
NOTE: The screw torque is 10 in-lbs and requires additional effort to release the screws.
Using both hands, rotate the handle and slowly pull the GPU tray toward the rear of the system.
Press and release the safety latch on both sides of the GPU tray.
Hold the GPU lifting handle and pull the tray out from the rear of the chassis.
Installing the GPU tray:
Lift and align the GPU tray with the rear of the chassis to ensure correct orientation.
NOTE: Two people are needed to carry the GPU tray from each side.
Using both hands, slowly push GPU tray along the track from the rear of the chassis.
NOTE: The GPU tray will slide forward and connect to the connector.
Using both hands, push the handle until it is in a vertical position and self-locks at the same time
Replace the GPU fan cage.
Replace the GPU fans.
Follow the procedure listed in After working inside your system.
Replace the system cover.
If applicable, install the system into the rack.
For more information, see the Rail Installation Guide relevant to your system at PowerEdge manuals.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
