Launch enterprise manager client click discover and configure uninitialized CV 2000 series storage centers. Verify that you have met all the prerequisites before continuing. Clicking next will discover all the uninitialized storage centers on the network. If you have multiple uninitialized storage centers, use the service tag to find and select the storage center, you would like to deploy. You can update the storage center name. You will need to enter the management IP addresses the top and bottom controller IP addresses Subnet mask, gateway domain name and DNS servers provide a password and admin email address for the alerts. Review the storage center setting summary, then click apply configuration to continue applying the configuration will take 5 to 6 minutes.
Verify that your cabling matches the diagram here. You'll see the worldwide names required for zoning. There are two columns, physical worldwide names and virtual worldwide names. This is by port which are divided up by fault domain one and fault domain two. Open up your switch zoning configuration to create your aliases. The first one will be the top controller port one physical worldwide name, use the zoning configuration chart to verify the worldwide name and create the alias, create a new alias. This time it will be for the bottom controller, fault domain. One follow the previous steps to find the appropriate worldwide name and add it to the alias. Next, create the virtual worldwide name aliases for fault domain.
One follow the previous steps again for both the top and bottom controller. Once the aliases are complete, create the zones, there will be two zones, physical and virtual, create the physical zone and add the two physical aliases to that zone. Repeat this for the virtual zone. Adding the virtual aliases once the zones are complete, create a new config and add the zones to the config, save it and then enable it. Repeat the zoning steps for the second switch, configure the time settings and click next. It is recommended to enable SMTP email alerts, click the SMTP email check box and enter 1 to 2 email addresses.
And optionally the sender email address and the subject line. It is recommended to accept the license agreements for the support assist system state collection, accepting this enables proactive service requests, automatic case creation, remote storage center upgrades, proactive notifications from technical support and health checks provide your contact information. This information is used for sending critical alerts and shipping replacement parts. Once you click next, the storage center will check for available updates. After applying updates, the wizard will automatically log into the storage center
