In this video, we will show how to auto configure RAID 0 on Dell PERC 9 or later. Note that this configuration is supported only on hard drives with H730, H730P, H830 controllers and is not supported on hard drives with H330 controller. Also, this will be effective only on physical disks that are in ready state.
The state of all online, DHS, GHS and foreign configurations remain unchanged. To begin the process, turn on the system, and press F2 to go to the System Setup page. Click Device Settings, and then Dell PERC 9. Now, click Physical Disk Management to check if all the connected physical disks are in ready state.
Then click Back. Click Virtual Disk Management to check if any disks have virtual configuration. And then click Back. Next, click Configuration Management, and then Auto Configure RAID 0. Select Confirm to continue the operation, and then click Yes. The operation is now completed successfully.
Click OK, and then click Back. And finally, click Virtual Disk Management to check if all physical disks that are in ready state are converted to RAID 0 virtual disks. For more information visit dell.com/support.
