Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
CAUTION: The hard drive tray is hot to touch for some time after the system has been powered down. Allow time for the hard drive tray to cool before handling it.
Removing the hard drive tray:
Disconnect the SAS, power, and signal cables from the hard drive backplane.
Lift the hard drive tray handles 90 degrees upward.
Hold the hard drive tray handles and lift the hard drive tray out of the chassis.
Installing the hard drive tray:
Lift the hard drive tray handles to the 90-degree angle position.
Hold the hard drive tray handles and align the slots on the hard drive tray with the guide pins on the chassis.
Slide the hard drive tray into the chassis.
Lower the hard drive tray handles to lock the hard drive tray in place.
Connect the SAS, power, and signal cables to the backplane.
Install the system cover.
If applicable, install the system into the rack.
If removed, install the front bezel.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the system, including any attached peripherals.
