Prerequisites
Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your system:
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet, and disconnect the peripherals.
Remove the system cover.
Remove the front bezel.
Disconnect the control panel cable and the control panel USB cable from the connector system board.
NOTE: Remove the control panel cables form the cable tie.
Removing the control panel assembly:
Using a Phillips 2 screwdriver, remove the screws that secure the system side cover to the chassis.
Tilt and slide the system side cover towards the rear of the system and remove the system side cover.
Pull out the tabs on both sides of the front faceplate and remove the front faceplate out of the system.
To remove control panel cage:
a. Press the side lever and slide out the control module cage from the system.
b. Disconnect the cable from the control panel assembly.
To remove control panel assembly:
a. Using a Phillips 2 screwdriver, remove the screws that secure the control panel assembly to the cage.
b. Slide out and remove the control panel assembly from the cage.
Installing the control panel assembly:
To install control panel assembly:
a. Align and slide the control panel assembly into the control panel cage.
b. Using a Phillips 2 screwdriver, tighten the screws that secure the control panel assembly to the cage.
To install control panel cage:
a. Connect the cable to the control panel assembly.
b. Slide the control panel cage into the system until clicks into its place.
Insert front faceplate tabs into the slots in the system and press until the front faceplate locks into place.
Tilt at an angle and align the system side cover with the slots in the system, then slide the cover towards the front of the system until locks into place.
Using a Phillips 2 screwdriver, tighten the screws that secure the system side cover to the chassis.
Connect the control panel cable and the control panel USB cable to the system board.
NOTE: Secure the control panel cables with the cable tie to prevent it form being pinched or crimped.
Follow the procedure listed in After working inside your system:
Replace the system cover.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
