Prerequisites
Follow the safety guidelines listed in Safety instructions.
Removing the optional front bezel:
Unlock the bezel.
Press the release button, and remove the left end of the bezel.
Slide the tabs on the right end of the bezel out of the slots on the chassis and remove the bezel.
Removing a drive blank:
Press the release button, and slide the drive blank out of the drive slot.
Removing the drive from the drive carrier:
Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screw driver to remove the drive.
Lift the drive out of the drive carrier.
Installing the drive into the drive carrier:
Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
Align the screw holes on the drive with the screws holes on the drive carrier.
Using a Phillips #1 screwdriver, replace the screws to secure the drive to the drive carrier.
NOTE If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screw driver to install the drive.
NOTE When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-pounds.
NOTE Use the screws shipped with the drive carrier to secure the drive to the drive carrier.
Installing the drive blank:
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Installing the optional front bezel:
Align and insert the tabs on the bezel into the slots on the chassis.
Press the bezel until the release button clicks in place.
Lock the bezel.
