Prerequisites
Ensure that you read the Safety instructions section in this document.
Complete the tasks listed in Before working inside your system section in this document.
Turn off the system, including any attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If installed, remove the front bezel.
If applicable, remove the system from the rack.
Remove the system cover.
Remove the cooling shroud.
Remove the PCIe card holder.
Remove all cables routed through the cable retention bracket.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
Removing the cable retention bracket:
Pull the tab to release it from the notch and slide the cable retention bracket toward the front of the chassis to release it from the chassis.
Lift the cable retention bracket out of the chassis.
Installing the cable retention bracket:
Align the cable retention bracket with the alignment pins on the chassis.
Slide the cable retention bracket along the chassis wall until the tab clicks and locks the slots.
Place all cables to be routed in the cable retention bracket.
Install the PCIe card holder.
Install the cooling shroud.
Complete the tasks listed in After working inside your system section in this document:
Install the system cover.
If applicable, install the system into the rack.
If removed, install the front bezel.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the system, including any attached peripherals.
