Prerequisites
Turn off the system, including any attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If installed, remove the front bezel.
If applicable, remove the system from the rack.
Remove the system cover.
If installed, remove the SD cards.
NOTE Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into the corresponding slots.
Removing the dual internal SD module:
Locate the internal dual SD module (IDSDM) on the system board. To locate the internal dual SD module connector, see the System board connectors section.
Holding the pull tab, lift the IDSDM out of the system.
a. IDSDM
b. pull tab
c. IDSDM connector
Installing the dual internal SD module:
Locate the internal dual SD module (IDSDM) connector on the system board. To locate the IDSDM connector, see the System board connectors section.
Align the IDSDM with the connector on the system board.
Push the IDSDM until it is firmly seated on the system board.
a. IDSDM
b. pull tab
c. IDSDM connector
Install the SD cards.
NOTE Re-install the SD cards into the same slots based on the labels you had marked on the cards during removal.
Install the system cover.
If applicable, install the system into the rack.
If removed, install the front bezel.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the system, including any attached peripherals.
