Prerequisites
Follow the safety guidelines listed in Safety instructions.
Power off the system and attached peripherals.
Disconnect the system from the electrical outlet, and disconnect the peripherals.
Removing the system cover:
Pull the system cover release latch.
Remove the system cover.
Lay the system on its side.
Removing a drive carrier from the drive bay:
Press the retention clips and lift the drive carrier out from the drive bay.
Removing a drive from the drive carrier:
Flex the drive bracket outwards to release the metal studs on the drive bracket from the holes on the drive.
Remove the drive from the carrier.
Installing a drive into the drive carrier:
Align the screw holes on one side of the drive with the pins on the drive carrier.
Flex the drive bracket outward, and align the metal studs on the drive bracket to the holes on the drive and place the drive into the drive carrier.
Installing a drive carrier into the drive bay:
Align and slide the drive carrier into the drive bay until it clicks into place.
Installing the system cover:
Align the tabs on the system cover with the slots on the chassis.
Press the system cover until it clicks into place.
Place the system upright on a flat, stable surface.
Reconnect the peripherals and connect the system to the electrical outlet.
Power on the attached peripherals and then power on the system.
