How to Install a Preparing Windows iSCSI Host Drivers for Dell Storage SC Series

This video will demonstrate the installation procedure of Preparing Windows iSCSI Host Drivers for the Dell Storage SC Series.

In preparing the server. We'll have 2 10 gig nicks. We'll need to assign IP addresses to them. Currently, they're un cabled so that we can identify which Nick port is connected to which fault domain, open up network and sharing center.

Then click change adapter settings. Here you can see all network adapters installed in the server. Notice that Ethernet seven is disconnected.

Once it is cabled, the status changes to identifying right click and click properties, disable I PV six and configure I PV four, configure the IP address to be on full domain one. Since we are not routing ice Guzzi traffic, we will leave the gateway blank.

We will repeat these steps for the network adapter on fold domain two. Make sure that when you configure the IP address that it's on the subnet mask for fault domain two. Once completed, your scuzzy host will be ready.