Prerequisites
Ensure that you read the Safety instructions section in this document.
Follow the procedure listed in the Before working inside your system:
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If installed, remove the front bezel.
If applicable, remove the system from the rack.
Remove the system cover.
Remove the BOSS-N1 module:
Pull and lift the BOSS-N1 card carrier retention latch lock to open.
Slide the BOSS-N1 card carrier out.
Removing the M.2 NVMe SSD module:
Using the Phillips #1 screwdriver, remove the M3 x 0.5 x 4.5 mm screw securing the M.2 NVMe SSD module to the BOSS-N1 card.
Pull the M.2 NVMe SSD module to disconnect from the BOSS-N1 card connector.
Installing the M.2 NVMe SSD module:
Align the M.2 NVMe SSD module at an angle with the BOSS-N1 card connector.
Insert the M.2 NVMe SSD module until it is firmly seated in the BOSS-N1 card connector.
Using the Phillips #1 screwdriver, secure the M.2 NVMe SSD module on the BOSS-N1 card with the M3 x 0.5 x 4.5 mm screw.
Install the BOSS_N1 module:
Slide the BOSS-N1 card carrier into the BOSS-N1 module slot.
Close the BOSS-N1 card carrier release latch to lock the carrier in place.
Follow the procedure listed in the After working inside your system.
Replace the system cover.
If applicable, install the system into the rack.
If removed, install the front bezel.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the system, including any attached peripherals.
