This video covers how to replace a cooling module in a Unity x00/F Series, x50/F Series, and 380/F disk processor enclosure (DPE).
In this video, we’ll show you how to replace an internal faulted cooling module in the Unity systems shown on screen and in the description below the video. Before you begin: Ensure that you always wear proper proper electrostatic discharge or ESD protection when working inside the system.
First, in Unisphere, verify the location of the faulted cooling module. From the enclosures page, locate the faulted part, marked in orange in the enclosure view. Make a note of which SP and fan slot the faulted part is in. Next, place the SP into Service Mode. The SP fault light should be alternating amber and blue when the system is in Service Mode. Now you’re ready to replace the faulted cooling module.
Remove the SP assembly from the enclosure. Make sure you remove the SP that you identified earlier and do not remove an SP while the ‘Unsafe to Remove’ LED is lit. Before you remove the SP, first remove the power cord, then label and disconnect any other cables other cables from the network ports. Do not remove the cables from the other SP assembly. Pull the torque-limit screw handle out of the SP assembly, then turn it counterclockwise to release the SP from the enclosure.
Use the handle to pull the SP out of the enclosure. Now, place the SP on a flat surface with the top facing up. Wait until all LEDs are off to make sure that the SP is fully powered off. This can take up to three minutes. Push down on the blue release button and slide the top cover back until it stops moving. Then remove the top cover and set it aside.
Locate the cooling module. When looking at the SP from the rear, the fans are numbered from 0 to 4. To remove a fan, remove the air flow baffle to access the cooling module. Press in on the tabs on both sides of the air flow baffle. Then, lift upward to remove it from the SP. First disconnect the power cable from the motherboard.
Then, press in on the blue release button on the front of the cooling module, and remove it from the motherboard. Now, install your replacement cooling module. Align the cooling module in the empty slot, and gently press downward to lock it into position. Connect the power cable to the connector on the motherboard. You’ve finished replacing the cooling module. Now, we need to put the SP back into the enclosure.
First, reinstall the air baffle by aligning the two retaining clips on the baffle with the slots on the sides of the SP. Firmly push down on the air baffle to secure it. Align the top cover with the slots on the sides of the assembly. Then, pull the top cover forward about half an inch to secure it in place. Finally, align the SP with the enclosure and slide it into the slot until it stops moving.
Turn the orange screw handle clockwise until you hear a click. Then, push the screw handle in until it clicks again. Finally, reconnect all of the back end cables you removed earlier, and then reconnect the power cable. Wait about 10 to 15 minutes after reinserting the SP into the system to let the SP fully boot back into Service Mode. Then, return to Unisphere and reboot the SP into Normal Mode. It can take up to 20 minutes for for the system to reboot.
You should also make sure that your new cooling module is recognized by the system and operating correctly, from Unisphere. To do this, on the enclosure summary page, confirm that the part’s status is ‘OK.’ You’ve now replaced a faulted cooling module. For more information on adding or replacing other components of the Dell EMC Unity system, go to the Dell EMC Unity Technical Documentation page, using the link in the description for this video.