This video shows how to replace the BOSS S2 Module on a PowerEdge R750xa. Before you begin, power off the system and disconnect all the attached peripherals. Ensure that you always use ESD protection when working inside the system.
For more information about safety guidelines, see the service manual at: Dell.com/PowerEdgeManuals. To begin, first remove the system cover. To do this, rotate the lock on top of the system cover to the unlocked position. Lift the latch to disengage the cover from the system. Then lift the system cover off.
For the BOSS S2 card carrier, lift the retention latch to release the BOSS S2 card carrier, then slide it from the BOSS S2 module. To remove the M.2 SSD card, you need to first remove the screw on the BOSS S2 card carrier, then pull it out of the carrier. Now, to remove the BOSS S2 module, remove the screw on the BOSS S2 module bay. Slide the module towards the front of the system, then lift it from the bay.
Now, disconnect the power and signal cable from the BOSS S2 module. Also remove the cables from the system board and replace with the cables shipped with the module. To install the replacement BOSS S2 module, first connect the power and signal cable to the connector on the BOSS S2 module. Slide it into the bay on the system. Then, secure the module by tightening the screw.
To install the M.2 SSD, you must align the card at an angle and insert it until it is firmly seated. Then tighten the screw on the carrier to secure it. Now, slide the BOSS S2 card carrier into the BOSS S2 module slot. Then, close the release latch to lock the carrier in place.
Finally, replace the system cover by placing the cover into its position on the system. Lower the latch to engage the cover onto the system. Then, rotate the lock on the top of the system cover to the locked position. You've replaced the BOSS S2 module on a PowerEdge R750xa. If you need more information or assistance, go to: Dell.com/PowerEdgeManuals.
