How to install a Wyse PCIe Card for Precision Rack 7910

This video will demonstrate the installation procedure of a Wyse PCIe Card for the Precision Rack 7910.

Prerequisites
Ensure that you read the Safety instructions.
Turn off the system, including any attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
Remove the system cover.
If installed, remove the full-length PCIe card.

Removing the PCIe card holder:
Press the release tab and slide the card holder toward the back of the chassis to release the PCIe card holder from the chassis.
Lift the PCIe card holder out of the chassis.
NOTE:To ensure proper system cooling, you must replace the PCIe card holder.
PCIe card holder
release tab

Installing the PCIe card holder:
Align the PCIe card holder with the notches and tabs on the power supply unit cage.
Press the release tab and slide PCIe card holder toward the front of the chassis until firmly seated.

If applicable, replace the full-length PCIe card.
Install the system cover.
Reconnect the system to its electrical outlet.
Turn the system on, including any attached peripherals.